Certified Safety Health Manager Exam Preparation
Certified Safety Health Manager Exam Prepration

Area II. Topic H. Root Cause Analysis

Introduction

"Root causes often relate to the management system. They may be due to management's policies and procedures, supervision and its effectiveness, or training. Root causes are those which would effect permanent results when corrected. They are those weaknesses which not only affect the single accident being investigated, but also might affect many other future accidents and operational problems." — Safety Management : A Human Approach, Dan Petersen, ASSE Pub.

Exam Question Banks (10 questions each) 1 2 3 4 5 6 7
References & Notes

  1. Hazard Identification and Control Basics
  2. Incident/Accident Analysis
  3. Accident Investigation Procedures
  4. Establishing Complete Hazard Inventories
  5. Establishing a Hazard Prevention and Control Program
  6. Catching the Hazards that Escape Controls
  7. Tools For Safety and Health Program Analysis
  8. Evaluating Your Safety and Health Program
  9. Hazard Analysis Basics
  10. The Five Whys Technique
  11. Creating a Simplified Fault Tree for Root Cause Analysis
  12. Event and Causal Factor Charting
Section Practice Exams (30 questions each) 1 2 3
Comprehensive Practice Exams (150 questions each) 1 2 3 4 5 6

Google
Disclaimer: This material is for training purposes only. Its purpose is to inform employers of best practices in occupational safety and health and general OSHA compliance requirements. This material is not, in any way, a substitute for any provision of the Occupational Safety and Health Act of 1970 or any standards issued by OSHA.

Copyright © 2000-2005 OSHA Training Network. All rights reserved. Disclaimer | Contact
OSHA Training Network, 515 NW Saltzman Road #767, Portland OR 97229-6098